LUSTRADOR – HOLOGRAM REMOVER

Product ready for use.

1. Shake the product.
2. Check that the surface to be applied is clean and dry.
3. Use an electric or pneumatic polisher with a Protelim foam nozzle.
4. Apply small amounts of the product and spread it over areas of approximately 50×50 cm under the beret.
5. Spread the product with a beret.
6. Operate the equipment between 1,400 rpm and 2,200 rpm, with medium pressure on the workpiece and slow, short movements.
7. Use Protelim Microfiber Flannel or absorbent cotton, if necessary, to remove and clean any impurities on the surface.
8. If necessary, repeat the application on the area to be polished.

IMPORTANT:

1. Do not apply this hologram remover in sunlight or when the surface is heated.
2. Use personal protective equipment (PPE).